|
|
Overview
The customer required a cost effective system that enabled industrial diamond
cutting. Objectives
The customer wanted a system that cut their diamonds, but also measured and
recorded the resistance on the blade, to obtain a higher degree of accuracy
whilst cutting. Solution
- Custom manufacture design, using an EL5000 Elevation stage to move blade down
onto the diamond
- Controller tuned for torque mode on diamond cutting wheel
- A servo motor was used, so torque could be measured and recorded
- Cutting tank and ancillary engineering all by
LG Motion Ltd. Industries
Limited
Benefits gained
- A higher degree of accuracy gained
from the recordings of resistance from the blade
Products used
|
